Manual

3.5 – Operation with Motor
3.5.1 – Döner-Grillmachine with Motor on Top
Operating your appliance with motor will enable both a homogenous meat grilling and
depending less on manual operation.
Please follow the following procedure to operate your appliance with motor.
(Figure 1-b)
- Unscrew (T) shaped arms of upper (3) and lower slides (15) Depending on the
diameter size of the meat, move these arms to the best position where the meat
can easily be skewered. Remove T shaped upper slide (3) arm completely.
When doing this counter-arm (16) must be located above upper slide arm (3).
Then, pass the T shaped upper slide arm through the mounting opening above
of the motor shield (17), and install it together with the motor (1) and screw.
When holding the motor in correct position with your hands, screw the counter-
arm (16) and the motor shield (17).
- Insert the bottom end of the skewer (6) with meat on, to the conical guide
located above lower slide (15), and tighten T shaped arm.
- Then move the top end of the skewer (6) closer towards the skewer guide.
Raise the snatching tube on the skewer guide up, and insert the skewered meat
into the skewer guide and snatch the tube.
- After doing this, ensure that both the bottom slide (15) and the upper slide (3)
are aligned.
- Then pass the motor cable (2) through cord holders, in order to protect the
cable from the heat generated during operation. (Use the heat cap (5) to protect
the cable from heat during operation)
- Your appliance is ready for use with motor. Plug electrical cord of the motor in,
and start it using the switch on it.
!
3 – OPERATION AND MAINTENANCE INSTRUCTIONS
When operating with motor always ensure that cords are kept away from
heat sources. For this reason, never attach the motor cord on cord holders
when operating.