User`s manual

NetWare (NCP)
24 AXIS StorPoint CD E100 User’s Guide
4. Enter the appropriate settings for these parameters:
5. Save the
config.ini file to start the NDS server installation. The installation takes about 15
seconds, after which users will be able to access the StorPoint CD in NDS mode.
6. To verify that the StorPoint CD was successfully installed, check the
logfile.txt file located
in the
System/ServerProperties folder for errors. After the installation you must log out
and then login again to have all the necessary rights on the StorPoint CD server object and the
associated volume.
Parameter name Value Description
TimeZone = Must be set to the correct time zone that the StorPoint CD is operating in. See
“Time Zone Parameter Values” in the “AXIS StorPoint CD E100 User’s Manual, Appendix A. -
Parameter List”.
TimeSyncSource = NDS Set to NDS to enable the StorPoint CD to get its time from the NetWare network.
IPXEnable = yes Set to yes to enable the IPX protocol.
PureIPEnable = no Set to no to disable PureIP for non-TCP/IP networks.
NDSEnable = yes Set to yes to enable the NDS login.
NDSTreeName = Specify the name of the tree where you want to install the StorPoint CD, e.g. MEDCORP
NDSServerContext = Specify the distinguished name of the context in the NDS tree where you want to install the
StorPoint CD, e.g. Manufacturing.Medtec
NDSAdminName = Specify the distinguished name of a user or administrator with Supervisor or Create rights to
the context where you want to install the StorPoint CD, e.g. Admin.Medtec
NDSAdminPassword = Specify the password of the administrator entered in NDSAdminName shown above. Once
written, this password will appear as ******.
NDSInstall = install Change this to install when you are ready to install the StorPoint CD. The setting forced will
overwrite the existing server object without warning.
NDSRightsStorage = NDS Set to NDS to store the access rights in the NDS tree. Set to File to store the access rights in a
file on the Novell server. This is necessary if you do not allow schema extensions in your NDS
tree, or if you do not have Supervisor access rights.
NDSRightsFile = If storing the access rights in a file on the Novell file server, specify the whole path to the file,
e.g. CORPSERVER/SYS:CDSERVER/CDSRV.DAT
The specified directory must exist and the StorPoint CD must have Read, Write, Create, Erase,
Modify and File Scan rights. The StorPoint CD will create the file once you start adding trustees.
You find a more detailed description in the “AXIS StorPoint CD E100 User’s Manual, Appendix B -
Troubleshooting”.
TimeSyncSources = SAP Default is SAP for the network agreed time. Alternatively, enter the server names to be
contacted for time synchronization.