Installation guide

Using NetWare/IP
To use the IP protocol in NetWare, you must set the Internet
address. See “Setup for TCP/IP”.
Follow these steps to set up the communication:
1. From Windows Explorer or File Manager, locate the
configuration file at
AXIS
nnnnnn
\config\config.ini
,
where
nnnnnn
are the last six digits of the serial number.
2. Open config.ini
with a text editor and enter the appropriate
settings for these parameters:
3. Reboot the StorPoint CD and wait 5 minutes. Clients that
support the NetWare/IP protocol will now connect directly to
the StorPoint CD, i.e. peer-to-peer. Clients without NetWare/IP
support will be routed through a Novell server with an IPX/IP
gateway.
Setup for TCP/IP
Windows 95, Windows NT, UNIX and OS/2
To access the StorPoint CD in the TCP/IP environment, e.g. from a
Web browser, you must assign a valid Internet address.
Assigning an Internet Address and a Host Name
1. Find an unused Internet address and choose a unique host name
for your StorPoint CD.
2. The host names are normally located in these directories:
• Windows 95 - c:\windows\hosts
• Windows NT - c:\winnt\system32\drivers\etc\hosts
• UNIX - /etc/hosts
• OS/2 - c:\etc\hosts
3. Add the Internet address and host name to your system host table
by appending the following line:
Example:
192.36.253.80 cdserv
4. If your system utilizes alias name databases such as Yellow Pages
(YP) or Network Information Services (NIS), you should update
these.
PrimaryDNS
The Internet address of the
primary DNS server.
SecondaryDNS
The Internet address of the
secondary DNS server, should the
primary DNS server be unavailable
or disconnected.
NetWareIP_Enable
Enables NetWare over the IP
protocol.
NetWareIP_DSS_Server
The host name or Internet address
of the DSS server.
<Internet address> <host name>