Installation guide

Connecting the Hardware
To install the StorPoint CD, follow these steps:
1. Connect the SCSI cable to the SCSI connector on the StorPoint
CD.
2. Connect the SCSI cable to the CD-ROM drive(s).
3. Set the SCSI address of the CD-ROM drives. Each connected
drive must be assigned a unique SCSI address. SCSI addresses 0
through 6 may be used. Refer to the CD-ROM drive
documentation.
4. Connect a SCSI terminator to the last drive in the SCSI chain.
The other CD-ROM drives should not be terminated.
5. Attach the network cable to the appropriate network connector.
6. If you have a Token Ring network, set the Ring speed switch to
the speed of your network; move the switch to the left for 4Mb/s
and the right for 16 Mb/s (as viewed from the rear).
7. Power up the drives, then the StorPoint CD. If installing the
standalone version, make sure all the drives are powered up
before the StorPoint CD. When the Status indicator stops
flashing and remains off, the StorPoint CD is ready for use.
8. Insert a disc into a drive and verify that the CD indicator turns
on. If it remains off, verify your SCSI cable connections and then
power cycle the StorPoint CD.
Rear view of the standalone version AXIS StorPoint CD
Rear view of the tower module AXIS StorPoint CD/T
Network connectors
Power supply connector
SCSI connector
Push button
(black push button)
Ring speed switch
Token Ring version)
(white slide switch on
Network connectors and Push button
Power supply connector
SCSI connector
Ring speed switch
Token Ring version)
(white slide switch on