User`s manual

Section 4: Setting Up - NetWare
48 AXIS StorPoint CD User’s Manual
Note: ❏
If logged in as Administrator, the NDS error message
“Insufficient rights” indicates that NDS has been corrupted. You
must repair or rebuild NDS. Repair NDS by entering the
LOAD
DSREPAIR
command at the server console.
Date and Time
The StorPoint CD clock has a volatile memory, which means that the
correct time must be set whenever it is restarted. The time can be set
manually by specifying the
Date
and
Time
parameter values, or it can
be set automatically via the network operating system.
Time Synchronization
in NetWare NDS
If you are using NetWare NDS, you can configure your StorPoint CD
for automatic time synchronization operation by setting the
TimeSyncSource
parameter to
NDS
. This is the default setting.
The StorPoint CD acts as a NetWare Secondary Time Server. Time
synchronization is normally obtained from a NetWare Time Server
using the SAP method. This is the default method, and is set by the
TimeSyncSources
parameter having a value of
SAP
.
Parameter name Value Description
[Server]
Date = 97-10-01 yy-mm-dd, enter the date followed by ! to set
manually.
Time = 14:00:00 hh:mm:ss, enter the time followed by ! to set
manually.
Parameter name Value Description
[Server]
TimeZone = Must be set to the time zone that the StorPoint
CD is operating in. Refer to “
TimeZone Parameter
Values
” on page 118
TimeSyncSource = NDS Specifies the time source for the StorPoint CD.
Set to
NDS
for NetWare NDS. Default is
NDS
.
Parameter name Value Description
[NetWare]
TimeSyncSources = SAP Default is
SAP
for the network agreed time.
Alternatively, enter the server names to be
contacted for time synchronization.