User`s manual

Section 2: Basic Installation
18 AXIS StorPoint CD User’s Manual
Connecting the StorPoint CD to the Network
Before you begin
Always consult the Network Administrator before making changes to
the network configuration.
Connecting to
the Network
To connect the StorPoint CD to your network, follow these steps:
1.
Turn off the power.
2.
Connect the network cable to the appropriate connector.
3.
If you have a Token Ring network, set the ring speed of your
StorPoint CD to the ring speed of the network (4 or 16 Mb/s) using
the Ring speed switch. Carefully slide the switch to the left to change
to 4Mb/s. For 16Mb/s, place the switch in the right hand position.
Note: ❏
The ring speed setting will not take effect until the StorPoint CD
has been restarted.
4.
Turn on power:
Standalone version only:
First connect power to all CD-ROM drives
and switch them on. Then connect the external power supply to the
StorPoint CD.
Tower module only:
Switch on the CD-ROM tower.
The StorPoint CD front panel indicators will flash during power-on
and self-test. When the Status indicator stops flashing and remains off,
the StorPoint CD is ready for use.