User`s manual

Section 2: Basic Installation
14 AXIS StorPoint CD User’s Manual
Installing the StorPoint CD/T in a CD-ROM Tower
Note: ❏
If you are installing a standalone module StorPoint CD, skip this
section and continue with “
Connecting CD-ROM Drives to the
StorPoint CD
” on page 15.
The AXIS StorPoint CD/T is installed in standard 5.25 inch
CD-ROM towers.
Caution
0
To avoid the risk of electrical chock or other injury, disconnect power
from the tower before removing the chassis.
If not already installed in a tower when delivered, follow these steps:
1.
Prepare the CD-ROM tower for the installation, e.g. by removing
the chassis.
2.
Make a note of the serial number of the StorPoint CD/T for future
reference during the network configuration described later. You will
find the number on the underside label.
3.
Slide the StorPoint CD/T into the tower.
4.
Fix the StorPoint CD/T with the four screws supplied. Use the
upper or lower holes depending on type of tower and mounting.
Caution
0
The length of the screws must
not
exceed 0.2 inch (5 mm). If they do,
the internal components of the StorPoint CD/T may be damaged.