User`s manual

Appendix A: Parameter List
AXIS StorPoint CD Token Ring - User’s Manual 87
Appendix A Parameter List
This section includes the StorPoint CD parameter list. It also explains the
StorPoint CD directory structure and how to edit the configuration settings.
The Configuration File
This table shows the parameter list stored in the config.ini file located in the
System/ServerProperties folder, see the “Directory Structure ” on page 91.
The middle column shows the default values, when applicable. The right-hand
column gives a brief description of the parameters.
Parameter name Value Description
[Server]
HardwareAddress = 00:02:31:11:00:86 The StorPoint CD hardware address. Default is the serial number.
You can set a Locally Administrated Address. The value shown is
an example only.
Date = 00-09-01 yy-mm-dd, enter the date followed by ! to set manually
Time = 12:00:00 hh:mm:ss, enter the time followed by ! to set manually
FactoryDefaults = no Set to configuration, volumeProperties or all.
SourceRouting = auto Set to off, single, all or auto.
Restart = no Set to yes to restart StorPoint CD.
TimeZone = UTC Must be set to the time zone that StorPoint CD is operating in.
Refer to “Time Zone Parameter Values ” on page 90.
TimeSyncSource = NDS Specifies the time source for StorPoint CD. Set to NDS for
NetWare IPX. Set to NTP for NetWare PureIP, UNIX and SMB
over TCP/IP. Note that you will need third party software on your
Windows NT server to obtain support for NTP. Set to None for
manually setting the time.
ServerPassword = pass The Supervisor, Administrator or Root user password used for
basically all protocols; i.e. HTTP, NetWare bindery, SMB user level,
SNMP and FTP. Once written into the configuration file, the
password will not be shown but replaced with *’s, representing
each letter of the password.
Shut Down = no Set to yes to shut down StorPoint CD.
[SCSI]
SCSITermination = on Always on.
JukeBoxLockTime = 0 Specifies the maximum duration for a data read operation during
multiple access requests to prevent disc changer fluttering. Default
is 0 seconds which disables the function.
Disconnect_Reselect = on Set to off to disable the disconnect/reselect function in the disc
drives.
BusMode = Asynchronous Specifies the transfer mode on the SCSI bus: Asynchronous,
Synchronous, Fast-10 or Ultra.
[IP]
InternetAddress = 192.36.253.80 The StorPoint CD IP address.
DefaultRouter = 0.0.0.0 The IP address for the default router. All traffic directed outside
the local network (according to the NetMask) is sent to the default
router. Any re-routing via other routers is done automatically. The
default 0.0.0.0 indicates that no default router is set.
NetMask = 0.0.0.0 Used to determine when the traffic should be sent via a router. For
example, the normal class C mask is 255.255.255.0. The default
0.0.0.0 indicates that automatic router sensing is used.
BOOTPEnable = yes Enables BOOTP IP address setup.
DHCPEnable = yes Enables DHCP IP address setup.
RARPEnable = yes Enables RARP IP address setup.
DomainName = Name of the domain to which StorPoint CD belongs.