User`s manual

Appendix D: Tower and Drive Installation
116 AXIS StorPoint CD Token Ring - User’s Manual
Serial Number The StorPoint CD serial number is found on
the labels at the underside of the server unit
and at the back of the tower.
You will need to know the serial number of
the unit if you are setting the IP address
manually.
Network Connector StorPoint CD is equipped with network connectors for STP (Media Type 1)
and UTP (Media Type 3).
Note:
When your StorPoint CD has been installed in a tower, the network
connector is found on the network connection board that appears at the
back of the tower. Note that the network cable cannot be connected directly
to the server unit.
SCSI Connector StorPoint CD has a SCSI connector for connecting disc drives, jukeboxes,
changers and LUN expanders.
Push Button The Push button is used for restoring the StorPoint CD parameters to the
factory default settings. See “Restoring Factory Default Settings” on page 100.
Ring Speed Switch The ring speed switch is used for setting the ring speed of the unit to the speed of
the Token Ring network, 4 or 16 Mb/s.
Installing StorPoint CD in a Tower
The StorPoint CD server is installed in standard 5.25 inch towers.
Caution!
To avoid the risk of electrical chock or other injury, disconnect power from
the tower before removing the chassis.
If not already installed in a tower when delivered, follow these steps:
1. Prepare the tower for the installation, e.g. by removing the chassis.
2. Attach the enclosed product label to the back of the tower. The serial number
also appears on the underside label of the StorPoint CD unit. The number will
be needed later during the TCP/IP configuration.
3. Slide the StorPoint CD unit into the tower.
00408C3E5207