User manual

17
Installing Camera Bracket
Axis 233D PTZ
2. Do this by aligning the two holes on the D2
camera bracket with the Axis ceiling bracket
adapter. Use (2) #10-32 ½” long screws, (2)
#10 lock washers, and (2) #10-32 hex nuts
that are included to secure the axis ceiling
adapter to the D2 camera bracket.
Required components (see component
checklist): Part # 1,2,3,9,10,11,& 12
5. The 1.25" standoffs will be inserted on
the upper portion of the D2.
.5"
.75"
This edge nests in arch at front of D2
This edge of the bracket faces back of the D2 enclosure
Axis 233D Ceiling bracket that came
with the camera. *This is a required
item for installation*
Align these 2
holes with the
D2 bracket
holes for the
Axis 233D
4. The Axis 233D PTZ camera requires a
1.25" spacing for optimal fit and operation.
Use (1) .75" standoffs and (1) .5" standoffs
that are provided to create a 1.25" standoff.
You will need to create 4 of these with the
included hardware.
1. To install the Axis 233D in the D2
Enclosure we must first install the Axis 233D
ceiling bracket adapter that came with the
camera onto the D2 camera mounting plate.
Axis 233D Ceiling bracket that came with the camera.
*This is a required item for installation*
3. Next follow the Axis 233D installation
instruction to secure the camera to the ceiling
bracket adapter that is now attached to the
D2 Camera Bracket.
Picture represents standoff location & orientation.
Height of standoffs will vary depending on camera used.