User manual

11
Camera Power Connection
The D2-CD-12V provides an 18” lead from the COOLDOME power circuit with the following common 12 VDC Barrel
connector, which is nearly and industry standard. Dotworkz provides the Right Angle version below.
The D2-CD-24V offers a simple DC jumper cable to connect camera power to the 24 VDC COOLDOME circuits.
All D2 environmental enclosures come standard with a 12VDC Right Angle Barrel Plug (3.3mm x 5.5mm
with a 1mm center pin) for majority of the IP cameras on the market.
Camera Power Setup
(STANDARD 12VDC CONNECTOR)
Right Angle Standard
Inline version
If you IP camera’s power connector is different but still accepts up to ~ 13VDC for power, please see our
section on Camera Power Setup (NON-STANDARD CONNECTOR) for instructions on how to power
your camera. Below are pictures of typical NON-STANDARD CONNECTORS.
DC plugs with NO center pin
Terminal pin connectors
Terminal connector
If you IP camera’s power requirements are for 24 VAC ONLY, please make sure that the D2
Environmental dome that you purchased is a 24VAC version. Cameras that run on 24VAC will not work
with the 12VDC and 110-240VAC versions of our D2 Environmental domes.
*NOTE: The only way a 24VAC camera will work on our 12VDC and 110-240VAC dome is if you, the
customer, provide a separate power lead into the dome for your camera. We have designed our domes
to be simple and efficient when it comes to powering our environmental component and camera. So when
it comes to cameras with 24VAC power requirements, we –RECOMMEND-- the 24VAC versions of our
Environmental domes for proper installation.
All D2 environmental enclosures come standard with a 12VDC Right Angle Barrel Plug (3.3mm x 5.5mm
with a 1mm center pin) for majority of the IP cameras on the market.
Camera Power Setup
(STANDARD 12VDC CONNECTOR)
Right Angle Standard
Inline version
If you IP camera’s power connector is different but still accepts up to ~ 13VDC for power, please see our
section on Camera Power Setup (NON-STANDARD CONNECTOR) for instructions on how to power
your camera. Below are pictures of typical NON-STANDARD CONNECTORS.
DC plugs with NO center pin
Terminal pin connectors
Terminal connector
If you IP camera’s power requirements are for 24 VAC ONLY, please make sure that the D2
Environmental dome that you purchased is a 24VAC version. Cameras that run on 24VAC will not work
with the 12VDC and 110-240VAC versions of our D2 Environmental domes.
*NOTE: The only way a 24VAC camera will work on our 12VDC and 110-240VAC dome is if you, the
customer, provide a separate power lead into the dome for your camera. We have designed our domes
to be simple and efficient when it comes to powering our environmental component and camera. So when
it comes to cameras with 24VAC power requirements, we –RECOMMEND-- the 24VAC versions of our
Environmental domes for proper installation.
Provided 12 VDC camera power connector can be cut-off & Stripped, using Dotworkz cable as a jumper
to install a non-standard power terminal connector, such as any shown below.
For Non-Standard Connector Plugs, consult camera supplier or online, if it is not supplied with your
camera model.