User`s guide

AXIS 7100 User’s Guide Using the AXIS 7100

3. If you want to send the image to more than one destination, press Select

to choose each destination:

Notes:

4. Repeat steps 2 and 3, until all desired destinations are selected.

Note:

5. Optionally, press Menu to change the default scanning parameters. You can

select temporary settings for Scan profile and Paper size. Use to

select the desired value.

Note:

6. Insert a single page on the flatbed or a stack of paper into the sheet feeder of

the attached scanning device.

For one single page or a stack of paper in the sheet feeder:

a. Press Send to scan and send the image to the selected destination in

one step.

For several separate pages or stacks of paper:

a. Press Add to scan each page.

b. Insert the next page and press Add again. Repeat the procedure until

all your pages are scanned.

c. Press Send to transmit the image to the selected destination.

7. During the scanning this message is displayed:

• When sending to a printer, note that the image can only be sent to one printer at a time.

• The image can not be sent to another destination type if a printer destination was previously

selected.

Be careful not to transmit images to an unwanted destination! The image will always be sent to

the destination currently shown in the display, whether explicitly selected or not.

Press the Cancel button to reset all temporary settings to the default values. All selected

destinations will be cleared.