User`s guide

Basic Installation AXIS 7100 User’s Guide
12
Assigning an IP Address to the AXIS 7100
Follow the instructions below to set the IP address from the Control Panel.
Important!
1. Power up the AXIS 7100 and press Menu when this message appears:
2. After a few seconds this display will be shown
3. Press Select to edit the IP address:
4. Press Menu to move through and highlight each digit, one at a time.
5. Use to increase or decrease each highlighted digit, as required.
6. Press Select to confirm the changes.
7. Press Menu to display the default router address setting:
8. Press Select to edit the default router address:
• This section can be ignored if you are using DHCP, RARP or BOOTP, as the IP address is set auto-
matically (DHCP is the preferred method for Windows NT networks, as it automatically sets
some of the parameters as well).
• A valid and unused IP address must be acquired from your Network Administrator.
• Connecting a PC-AT keyboard directly to the mini-DIN connector on your AXIS 7100 provides a
convenient method for managing the unit, and setting the IP address during system start up.