Technical data

IV.3 PC interface
With the operating software BS7200 you can carry out the setting of the operating, positional,
and motion parameters, using a normal commercial personal computer (PC).
While all supply voltages are switched off, use the special 9-core interface cable to connect
the PC interface (X6) of the servo amplifier to a serial or parallel port of the PC.
The interface in the servo amplifier is electrically isolated by optocouplers.
Connection to a parallel port :
Use our 9 pole parallel interface cable
Connection to a serial port
Use our 9 pole serial interface cable with external power supply.
The minimum requirements for the PC are as follows:
Processor : 80386 or higher
Clock : 16 MHz or higher
Operating system : MS-DOS (3.3 or higher)
Graphics card : VGA
Monitor : s/w or colour
Drive : 3.5" diskette drive, hard disk
Interface : one free port (COM1, COM2, LPT1 or LPT2)
LPT1 : Adress 378
COM1: Adress 3F8
LPT2 : Adress 278 COM2: Adress 2F8
System (config.sys): Buffers : 30 or higher
Files : 30 or higher
Stacks : 0,0 or not defined
environment : the size must be set (/E:xxx) to 1024 bytes
or higher with the following syntax :
shell = command.com /E:1024
Further advice can be found in the manual for the BS7200 operating software.
- A.4.011.1/9
Chapter IV Interfaces and options Page IV - 3
digifas™ 7100 series 01.98 - A.4.011.1/9