Specifications

Greasing Procedures
Advanced Dicing Technologies Ltd.
3.4-6
3.4.3.1 Removing the Old Grease from the Y and Z Axes
On a quarterly basis, the old grease should be removed from the Y and
Z Axes before applying new grease.
To Remove the Old Grease from the Y and Z Axes:
1 In the Video Workspace, click and hold the down arrow (in the group of
arrows on the right of the Workspace) until the Z Axis reaches its
lowest position.
2 Open the Front Clear Cover.
3 Remove the eight screws (2 on front, 4 on top, 2 on back) that secure
the Z Casting Cover and remove the Cover.
4 Remove the four Y Bellows Cover screws and move the Bellows to one
side.
5 Remove the old grease from the Leadscrew using waste paper.
6 Grease the Y and Z Axes, as described in section 3.4.3.
7 Re-attach the Y Bellows to the Y Bellows Cover, using the screws
previously removed.
8 Re-attach the Z Casting Cover, using the eight screws previously
removed.
9 Close the hinged Spindle Cover.
1 Screws on Z
Cover (6 of 8)
2 Y Bellows Cover
3 Camera Cover
Figure 3-6: Z Casting Cover
1
2
1
3