Specifications

ADT Model 7100 Semi-Automatic Dicing System Maintenance Manual
Greasing Procedures
P/N 97100-9005-000-14 Ver 06/05
3.4-1
3.4 Greasing Procedures
This section describes the greasing procedures for Axes and Leadscrews on
the Model 7100. These components must be properly greased to ensure
reliable System operation, otherwise they can wear down and cause
inaccuracies.
The following components should be greased every month:
• X Axis
• Y and Z Axis
3.4.1 Greasing Equipment
3.4.1.1 Grease Gun
Advanced Dicing Technologies recommends the Model KH-120 Grease Gun
(P/N 27795-0501-000). The Grease Gun is manufactured to meet the
JISB9808-Grease Gun-L100 standard.
The Grease Gun may have either a press or pull-type lever for applying
grease.
3.4.1.2 Grease Type
Use ISOFLEX NBU15 grease (P/N 39087-0016-000). Contact ADT
Customer Support for purchasing information.
3.4.1.3 Waste Cloth
Make sure that there is a sufficient supply of waste cloth available during
greasing. Waste cloth is used for wiping off old grease or excess grease that
Note: Greasing requires basic knowledge of System operation. Please refer to
the ADT Model 7100 Semi-Automatic Operations Manual for the relevant
operation procedures, as well as the safety precautions in the Safety First
section at the front of this manual, before starting the greasing procedures.
Note: Any Grease Gun that meets the JISB9808 standard may be used. The
Grease Nipples on the Model 7100 meet the JISB1575 standard.
Note: If the Model KH-120 Grease Gun is ordered from ADT, it is delivered
greased with ISOFLEX NBU15 grease.
Caution: The Leadscrews and Linear Guides are greased before shipment of
the System to the Customer. ADT uses long-life grease that exhibits minimal
liquid-oil separation. If a different type of grease is used, there may be changes
in the greasing interval requirements, as well as chemical reactions between
the new grease and the remaining ISOFLEX NBU15 grease. It is therefore
essential to use the correct grease.