Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Placing/Removing a Workpiece
P/N 97100-9002-000-14 Ver 06/05
3.5-1
3.5 Placing/Removing a Workpiece
To Place a Workpiece on the Cutting Chuck in Auto Mode:
1 Click the Run button in the toolbar.
2 Place a Workpiece on the Cutting Chuck, following the Wizard
instructions.
3 Close the Load/Unload Cover and click Finish in the Wizard.
To Place a Workpiece on the Cutting Chuck in Manual Mode:
1 Click the Load/Unload Wafer button , or from the Manual
menu, select Services > Place Workpiece, or press Ctrl+L.
2 Place a Workpiece on the Cutting Chuck.
3 Close the Load/Unload Cover and click Finish in the Wizard.
To Remove a Workpiece from the Cutting Chuck in Auto Mode:
1 Follow the Wizard instructions.
2 Click Finish in the Wizard, when prompted to do so by the System.
3 Remove the Workpiece from the Cutting Chuck.
A Workpiece can also be unloaded by pausing the process and clicking
, or using manual unload while the process is paused.
To Remove a Workpiece from the Cutting Chuck in Manual Mode:
1 Click the Load/Unload Wafer button , or from the Manual
menu, select Services > Remove Workpiece, or press Ctrl+R. The
Load/Unload Cover disengages.
2 Click Finish in the Wizard.
3 Remove the Workpiece from the Cutting Chuck
Note: Remove operation is available only after the machine has finished
cutting the Workpiece.