Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Powering Up/Down Procedures
P/N 97100-9002-000-14 Ver 06/05
3.1-1
3.1 Powering Up/Down Procedures
3.1.1 Powering Up the System
This section describes the procedure for powering up the Model 7100 at the
beginning of a session. Once powered on, the Model 7100 can be run
continuously. It only needs to be powered down in order to perform repair
and maintenance procedures. For additional information about powering
down the System, see
section 3.1.2.
To Power Up the System:
1 Turn on the main Circuit Breaker at the right side of the System, if it
has been turned off (normally it is left in the On position).
2 On the System Front Panel, press the ON button. The PC inside
the System turns on and automatically launches the Model 7100
software.
3.1.1.1 Powering Up After an Abnormal Shut Down
In case the System has abnormally shut down, the user has to restore the
process database. Follow the on-screen instruction of the Database
Note: Before powering up the system, make sure that both the computer and
the monitor are powered off (monitor LED is off).