Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Graphical User Interface
P/N 97100-9002-000-14 Ver 06/05
2.2-27
Model
After the Teach procedure has been performed, the Model tab displays the
Model that was taught. During Alignment or Kerf Checking, the Model tab
displays the Model currently being searched.
2.2.10.2.6 Main Workspace Window
The Main Workspace Window provides a small representation of the Main
Workspace, as described in
section 2.2.10.1. It depicts the Dicer from
above, including the Workpiece (if present), the Spindle and the Blade.
The User can manipulate the Main Workspace Window the same way as in
the Main Workspace. For example, right-clicking anywhere in the Main
Workspace Window displays the popup menu shown in
Figure 2-18 and
described in section 2.2.10.1.1.
When working in the Video Workspace, it is useful if the Main Workspace
Window displays a close-up of the Cutting Chuck showing the Cut Map of
the current Workpiece (if one has been defined), including the position of
all Index cuts.
Figure 2-2: Model Tab