Installation guide

Graphical User Interface
Advanced Dicing Technologies Ltd.
2.2-22
Double-clicking any point in the FOV bring the FOV center to that point.
Center-clicking moves the FOV center 1 pixel along the axes, depending on
the zone clicked:
Z/T Axis Controls
The Z/T Axis Controls (right Display Control) move the image displayed in
the FOV along the Z and Theta Axes.
The left and right arrows rotate the Cutting Chuck along the Theta Axis.
The exact position on the Theta Axis is displayed in the T field. The up and
down arrows move the camera along the Z-Axis (change the focus of the
camera on the Workpiece). The exact position on the Z-Axis is displayed in
the Z field.
Clicking the central box changes the type of movement, as follows:
F: Moves at the Fast Velocity, as defined in the Z and T Axis
parameters in the Setup & Diagnostics workbook.
S: Moves at the Slow Velocity, as defined in the Z and T Axis
parameters in the Setup & Diagnostics workbook.
P: Moves one pixel at a time.
A: Toggles between the angles defined in the Recipe.
X Axis
Y Axis
Click here to move 1 pixel up
Click here to move 1 pixel down
Click here to move 1 pixel to the right
Click here to move 1 pixel to the left
Note: The axes can also be moved by typing in coordinates values and
pressing Enter.
Note: For more information about the Setup & Diagnostics workbook, refer to
the ADT Model 7100 Semi-Automatic Dicing System Maintenance Manual.