Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Graphical User Interface
P/N 97100-9002-000-14 Ver 06/05
2.2-9
2.2.3.4 Wafer Holder Gauge
Wafer Holder Gauge indicates the status of the wafer
(substrate) Vacuum level.
2.2.3.5 Water Adjust
The Water Adjust Gauge indicates the flow rate and spray of
the cutting water and cleaning jets.
Pressing the Water Adj. button activates the water flow.
2.2.4 Dicer Status Indicator
The lower right section of the main window displays the status of the Dicer.
The status of the Dicer is indicated by the following LEDs:
• Red: An error/failure exists. The System stops working and an error
message appears on the screen.
• Yellow: User assistance required. A message appears on the screen.
• Green: When blinking, the station is carrying out an operation.
Otherwise, green indicates that the station is in idle mode.
For example, when placing a Workpiece on the Cutting Chuck, at the point
when the User should load the Workpiece, the yellow light goes on.
The User can also initialize the Dicer by right-clicking the Dicer Status
Indicator and selecting (Dicer) Init from the popup menu displayed. For
further information about initialization, refer to
Chapter 10.
Double-clicking on the Dicer Status Indicator displays the last error
message.
Figure 2-12: Dicer Status Indicator