Installation guide

Recipe Parameters
Model Precessing Parameters
Advanced Dicing Technologies Ltd.
A-42
Model Precessing Parameters
Table A-22 lists the parameters in the Model Processing category.
Manual
Inspection
Oblique
Illumination Before
Cut
Defines the intensity of Coaxial Illumination for the
Manual Inspection before cut.
Possible Values:
min = 0, max = 255, Default = 0
Manual
Inspection
Rate
Possible Values:
min = 0, max = 255, Default = 124
Table A-21: Manual Inspection Parameters
Category Parameter Description
Table A-22: Model Processing Parameters
Category Parameter Description
Model
Preprocessing
Delay After
Preprocessing
Defining the delay enables the user to review the
models after preprocessing. The delay is used only
for defining the preprocessing parameters for the
specific process.
Optional values: 0 - 20, default = 0. Units [Sec]
Model
Preprocessing
Method Iterations
Defines the number of iterations for each filter defined
in the Processing Method. This feature follows the
same principles as those of sub-indexes.
Possible Values:
min = 1, max = 20, Default = 1
Model
Preprocessing
Processing
Method
Defines the algorithm to be used. It works like sub
indexes. Read the chapter describing each filter.
Optional values: Close Morphology, Open
Morphology, Vertical Edge Filter, Horizontal Edge
Filter, Smooth Filter, Edge Filter.
Model
Preprocessing
Processing
Method for All
Models
Provides the Vision a capability to perform the pre-
processing for each model, i.e., sub, main, low.
Optional values: Close Morphology, Open
Morphology, Vertical Edge Filter, Horizontal Edge
Filter, Smooth Filter, Edge Filter.