Installation guide

Recipe Parameters
Loop Cut Parameters
Advanced Dicing Technologies Ltd.
A-40
Loop Cut Parameters
Table A-20 lists the parameters in the Loop Cut category. Loop Cut
parameters define the way the Model 7100 cuts using the Standard APC
algorithm and repetitive patterns.
Manual Inspection Parameters
Table A-21 lists the parameters in the Manual Inspection category.
Table A-20: Loop Cut Parameters
Category Parameter Description
Loop Cut First Angle
The angle where the loop starts.
Possible Values (Pure):
min = 0, max = 99, Default = 0
Loop Cut Last Angle
The angle where the loop ends.
Possible Values (Pure):
min = 0, max = 99, Default = 0
Loop Cut
Number of
Repetition
The number of times a loop is performed.
Possible Values:
min = 0, max = 1024, Default = 0
Loop Cut X Shift
The offset from the last cut position in the X direction,
between the loop repetitions.
Possible Values:
min = -990, max = 999, Default = 0
Loop Cut Y Shift
The offset from the last cut position in the Y direction,
between the loop repetitions.
Possible Values:
min = -990, max = 999, Default = 0
Table A-21: Manual Inspection Parameters
Category Parameter Description
Manual
Inspection
Activate
Defines whether or not the Manual Inspection feature
is activated.
Optional Values:
Yes, No (Default)
Manual
Inspection
Coaxial
Illumination After
Cut
Defines the Coaxial illumination intensity for the
inspection that is done after the cut. (This parameter
value is inserted manually).
Possible Values:
min = 0, max = 255, Default = 0