Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Dress Block Parameters
P/N 97100-9002-000-14 Ver 06/05
A-33
Dress Block Dress/Chop Depth
Cut depth to which the blade enters the Dressing
Block as related to the Dress Station surface.
Options: 0.1 - 5 mm. Default = 1
Dress Block Dress/Chop Rate
Defines the number of wafer cuts, after which the
System performs blade dressing.
Options: 0 - 100 cuts. Default = 0
Dress Block
Dress After a No.
of Heights
Defines the number of Height procedures, after which
the System performs blade dressing.
Options: 0 - 100 Height Procedures. Default = 0
Dress Block Dress Cut Length
Defines the total cut length of the Dressing Block,
including the over-travel.
Options: 0 - 60 mm. Default = 40
Dress Block
Dress Cutting
Speed
Defines the X-Axis speed in dressing process
(relevant only for Cut mode).
Options: 0.001 - 100 mm/sec. Default = 1
Dress Block Dressing Mode
Defines the dressing mode used in a specific recipe. It
is important to select the mode before setting the
other parameter values.
Options: Cut (Default), Chop
Dress Block Height After Dress
Defines if dressing should be followed by Height
procedure.
Options: Yes (Default), No
Dress Block
Height Before
Dress
Defines if dressing should be preceded by Height
procedure.
Options: Yes, No (Default)
Dress Block
Number of Dress/
Chop Cuts
Defines the number of cuts in either dressing mode,
required for sufficient blade dressing.
Options: 1-100, Default = 2
Dress Block
Dress Spindle
Speed
Defines the Dressing process spindle speed.
Options: 1 - 60 KRPM, Default = 10
Table A-14: Dress Block Parameters
Category Parameter Description