Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Cut Verify Parameters
P/N 97100-9002-000-14 Ver 06/05
A-29
Cut Verify Number of Models
Enables the verification of two models to be used for
Average Index with Nominal Distance.
While performing the Average Index procedure with
two models, the value of this parameter should be: 2
Optional values: 1 (default), 2
Cut Verify Rate
The number of cuts between each instance of Cut
Verification.
Possible Values:
min = 0, max = 999, Default = 10
Cut Verify Recover Option
When Pause is selected, if model detection fails, the
system displays an error message and forces the
user to repeat the Cut Verify sequence, using
automatic Cut Verify or manual cut verify, until it
passes.
If Report is selected, the system displays an error
message, but continues cutting according to the
original index, until the next cut verification, defined by
the Cut Verify rate.
Optional values: Pause (default), Report
Cut Verify Settling Time
The amount of time the Workpiece is allowed to dry
before the Cut Verification begins.
Possible Values:
min = 0, max = 20, Default = 0.5
Cut Verify Special Search
If "Yes" is selected and in case the original model has
not been found, the system performs a search along
the X-Axis for Cut Verification Models.
Possible Values:
Yes, No (default)
Cut Verify Use Y Shift
If it is set to Yes, the Cut Verify models are searched
relatively to the cut position and Cut Map Y Shift.
If it is set to No, the Cut Verify models are searched
relatively to the cut position only.
Optional values: Yes (default), No
Cut Verify
Verification Offset
Tolerance
This parameter defines the acceptable offset
deviation during cut.
This parameter is used when the X Search parameter
value is greater than 1.
Table A-10: Cut Verify Parameters
Category Parameter Description