Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Align Algorithms
P/N 97100-9002-000-14 Ver 06/05
A-9
to cut regular round or rectangular Workpieces placed in the center of the
Cutting Chuck.
Standard Dressing
The Standard Dressing algorithm is used to control the Blade Dressing
procedure. It is used for both dressing Workpieces and dressing blocks. For
more information about Blade Dressing, see
Chapter 7.
Standard GPC
The Standard GPC algorithm is used to control the cutting process when
working with round or rectangular Workpieces placed in the center of the
Cutting Chuck. In Standard GPC, once the Index and reference point have
been defined for a Workpiece, it is possible to perform all the necessary
cuts in that Workpiece.
Align Algorithms
The Align algorithms control the manner in which the System performs
Auto Alignment and Alignment on a Workpiece. The following Align
algorithms can be selected:
• Full Auto Alignment
• Full Dress Alignment
Full Auto Alignment
The Full Auto Alignment algorithm is used to control the Auto Alignment
procedure. Auto Alignment can only be performed once Alignment has been
taught.
There are no compulsory parameters that have to be included in
the Recipe in order for Auto Alignment to be performed, since all necessary
parameters are generated by the Full Teach Alignment procedure.
However, it is recommended that the default values assigned to the
parameters when they are generated be modified as necessary.
Full Dress Alignment
The Full Dress Alignment algorithm is used to control the Alignment
procedure on a Dressing Workpiece. Full Dress Alignment can only be
performed once Alignment has been taught.
In order for Full Dress
Note: The Standard Dressing algorithm is applicable only when using a
dressing block or workpiece mounted on the Chuck as the dressing medium.
Note: Do not change the following parameters: Alignment X-Shift, Alignment
Y-Shift, Align Exact Angle, Align Points No and Alignment Taught.