Installation guide

Wash Pipe
Advanced Dicing Technologies Ltd.
9.4-2
The washing mechanism is based on the Wash Pipe and a toggle move of
the X axis between the two points - A and B (see
Figure 9-26).
The Wash Pipe can be retrofitted into an existing machine or installed at
the factory. In order to enable the Wash Pipe, the corresponding option in
the Model 7100 configuration screen should be set to Yes (refer to the
following procedure). The Wash Pipe water supply works simultaneously
with the Cooling Block.
The following Setup and Diagnostics parameters, that reside under the
Axis Point Category, need to be defined (see
Figure 9-27 below):
• Left Washing Position - defines the position of point A, shown in
Figure 9-26.
• Right Washing position - defines the position of point B, shown in
Figure 9-26.
Refer to Table A-29 in Appendix 3 for a list of Wash Pipe program
parameters that have to be defined before using this feature.
Figure 9-27: Wash Pipe Setup and Diagnostic Parameters