Installation guide

Dress Station
Advanced Dicing Technologies Ltd.
9.3-8
9.3.4.3 Dressing Block Cut Mapping
Once the Dressing parameters (see section 9.3.4.1 and section 9.3.4.2) have
been setup, follow the Dress Block Change Wizard instructions in order
to build the dressing Cut Map, which is displayed in the Simulation
window as shown in
Figure 9-23
After replacing a dress block, click Finish in the Dress Block Change
Wizard to maintain the previous dress block setup.
1 Chop Mode Cut
Map
2 Cut Mode Cut
Map
Figure 9-23: Dressing Cut Map Animation
1
2
Note: The Dressing Cut Maps are built in different directions: when in Cut
Mode, the System builds the Cut Map from the top of the Dressing Block to the
bottom, whereas in the Chop mode it builds the Cut Map from the bottom of the
Dressing block to its top ("Top" and "Bottom" are as related to the animation
displayed). The animation is updated as the current cut is completed.
Figure 9-24: Dress Block Change Wizard