Installation guide

Tilted Spindle
Advanced Dicing Technologies Ltd.
9.2-6
If one of the sensors detects that the Spindle or the Camera is at a wrong
angle, no angle indicator illuminates and an error message is displayed
(see
Figure 9-19).
9.2.3.1 Changing the Spindle Angle From Tilted to Level Position
To Change the Spindle Angle From Tilted to Level Position
1 Click on the Change button (see Figure 9-16). The dicer moves to the
Change station. The yellow light on the Light Tower lights, and the
"Spindle Angle change in progress" message appears in the lower
left corner of the screen.
2 In the wizard click Next. The GUI returns to the Setup screen.
3In the Setup screen, locate the Spindle Angle parameter and change
the angle value from 15 to 0, by selecting the new value from the drop-
down list.
4 Click Save.
Figure 9-19: Error Message
Note: This message and the Light Tower indication remain until the Y-Offset
procedure is performed.