Installation guide

Autoloader
Advanced Dicing Technologies Ltd.
9.1-10
Select MHS from the Setup & Diagnostics tree to display the following:
In the upper left pane of the MHS main screen, the user can define the
values of Dry system speed. In the Software Version 5.1 or later, the Top
Side Dry Speed parameter can be added to a Process Program a number
of times so that the workpiece is dried several times before it is placed back
into cassette.
In the lower right pane, the user can do the following:
• Engage and release vacuum:
Clear the Vacuum check box to release the vacuum. Select the
Vacuum check box to engage the vacuum in the Vacuum Cups.
The gauge within the Vacuum area indicates the level of the vacuum when
engaged. To set the vacuum level, press
CTRL+P in order to enable the
Vacuum gauge, then click within the green zone of the gauge and drag
until the desired level is displayed above the gauge.
• Activate and deactivate the Vacuum Cups:
Click Pick Up to activate the Vacuum Cups while elevating the Pick-Up Arm.
Click Drop On to deactivate the Vacuum Cups while lowering the Pick-Up
Arm.
• Activate/Deactivate the backside Dry System:
Select the Backside Dry check box to activate the Dry System. Clear
the Backside Dry check box to deactivate it.
Figure 9-7: MHS General Screen