Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Autoloader
P/N 97100-9002-000-14 Ver 06/05
9.1-7
In the lower right pane (identical for Elevator and Finger screens), the user
can do the following:
• Position the axis manually: Move the module along its axis in one of
the following ways:
• Click and hold one of the arrow buttons.
Clicking the button between the arrows selects whether the slider
moves fast (F) or slow (S), as defined by the Fast Velocity and
Slow Velocity parameters in the upper pane.
• Enter an axis position in the edit box (next to the Move button)
and click Move.
• Initialize the selected axis: Click Init.
• Perform a Self Test: Click Toggle Self Test to have the axis move
automatically between its home position and its limit. The axis
continues to move back and forth until Toggle Self Test is clicked
again
.
The upper right pane includes parameters that define the Scale Factor,
speed and travel of the selected axis.
The following parameters can be defined in the upper right pane of the
Elevator screen:
• Fast velocity - velocity, at which the Elevator moves when the button
between the arrows (see above) is set to (F).
• Acceleration
• Slow acceleration
• Deceleration
• Kill deceleration
• Self test delay
• LU - Elevator Load/Unload station coordinate
• Elevator wafer wait position
• Cassette setup start pos - Elevator position, when starting a New
Cassette Setup
• Elevator cassette slot 1 - Z-coordinate, to which the Elevator
descends to pick up the frame from the lowest slot
The following parameters can be defined in the upper right pane of the
Finger screen:
• Fast velocity - velocity, at which the Finger moves when the button
between the arrows (see above) is set to (F).
• Acceleration