Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Autoloader
P/N 97100-9002-000-14 Ver 06/05
9.1-3
Linear Arm moves into position, the Upper Dry System at the front of
the Pick-Up Arm dries the top surface of the frame.
8 The Pick-Up Arm grabs the frame with its four vacuum cups and holds
it while the Linear Arm returns the frame to the Autoloader. As the
Frame passes over the lowered Curtain, the Lower Dry System
attached to the Curtain dries the bottom surface of the frame.
9 The Linear Arm returns to its Load/Unload Station. The Pick-Up Arm
places the frame on the Elevator.
10 The Elevator moves to the level of the slot from which the frame was
taken.
11 The Finger grabs the frame and slides it into its slot.
These steps are automatically repeated on the remaining frames until all
frames are processed. The system notifies the user when the Cassette
needs to be replaced.
For more information regarding the Autoloader mechanical units, refer to
the 7100 Series Maintenance Manual.
9.1.2 Autoloader User Interface
This section describes the features added to the Model 7100 user interface,
in order to support the Autoloader.
Figure 9-2: Autoloader Features in the Model 7100 User Interface