Installation guide

Spindle Velocity
Advanced Dicing Technologies Ltd.
8.5-2
8.5.2 Reduced Vision Spindle Velocity
This feature allows the user to set a different spindle speed to be used
while the Vision Tasks (Inspection, Teaching Alignment, Auto/Manual
Alignment, Kerf Teaching and Checking, Cut Verification) are performed.
This feature is useful if the spindle vibration affects the image on the
monitor. This may happen if the Blade and the Flange are not balanced.
If the image looks blurry:
• Ensure that the Blade and the Flange are balanced
• If possible, work at a different spindle speed.
If the problem of the blurry image still persists, use the Reduced Vision
Spindle Velocity function. Upon setting the desired value in the Reduced
Vision Spindle Velocity parameter, the spindle speed will be reduced to the
defined value, while performing all Vision Tasks.
To Set the Reduced Vision Spindle Velocity Parameter
1 Click the button in the toolbar to open the Workbook Workspace.
2Select Setup and Diagnostics > Saw > Dicer.
3 Under the Saw parameters, set the Use Reduced Vision Spindle
Vel parameter to "Yes".
4 Set the Reduced Vision Spindle Vel parameter to the appropriate
value in rpm/krpm.