Installation guide

Introduction
Advanced Dicing Technologies Ltd.
1-2
1.2 Standard Features
The Model 7100 Series includes the following features:
• Single Head dicing machine
• Single Magnification Vision System
• Kerf Check Monitoring
• Brushless Spindle:
• DC, 60,000 RPM, speed controlled Front Mount Air Bearing
2"
Spindle (7100 Vectus and 7100 ProVectus)
• AC, 30,000 RPM, speed controlled Air Bearing 4" Spindle
(7100
Fortis)
• DC, 30,000 RPM, speed controlled Air Bearing 4" Spindle
(7100
ProFortis)
• Quick-Change Chucks that hold Workpieces in place using vacuum
suction
• Load Monitoring: enables the User to measure the load on the
Spindle (measured in Amps) caused by resistance encountered by the
blade during operation.
• Daily Database Backup
• Water Cleaning Jets: enables additional cleaning of the Workpiece.
• Un-Interruptible Power Supply (UPS) for the PC - used in case of
an emergency stop to prevent abnormal computer shut down.
1.3 Modes of Operation
The Model 7100 Series is operable as follows:
• Auto Mode: Requires no User intervention once Run is clicked.
Workpieces commonly used in the Customer’s System are processed in
Auto mode. The entire process, including Alignment, dicing, Kerf
Checking and getting to the Unload station after the process is
finished, is completely automatic.
• Manual Mode: This mode is used for dicing Workpieces that are
difficult to process automatically, for example:
• Damaged or partial Workpieces
• Workpieces that are difficult to align automatically
• Partially cut Workpieces
• After the process is finished, the user needs to click the Unload
button to remove the workpiece from the dicer.