Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Chuck Change
P/N 97100-9002-000-14 Ver 06/05
7.5-1
7.5 Chuck Change
The Model 7100 can use various cutting chucks, designed for different
production needs and applications. Chuck replacement can be carried out
on-site and does not require ADT Field Service staff involvement.
The chuck replacement procedure is performed in two steps, completed in
the following order:
1 Replacing the Chuck
2 Reteaching the Focus on the Chuck
7.5.1 Replacing the Chuck
When replacing a chuck on the 7100 dicing saw, there are three
replacement options, depending on the chuck’s thickness:
• replace a chuck of the same thickness
• replace a Thin chuck with a Thick one
• replace a Thick chuck with a Thin one
To replace a chuck of the same thickness
1 Access Z-Axis parameters: Workbook Workspace > Saw > Dicer >
Axes > Z.
2 Check the following Z-Axis parameters and verify that they are correct
with regards to the new chuck:
• Pre Non Contact Height Position
• Calibration Start Position
3 Browse to Chuck screen (Workbook Workspace -> Saw -> Dicer ->
Chuck) and click Chuck Change icon
Note: the following rules apply to possible scenarios while replacing chucks:
• If both Thin and Thick Chucks are in use, ALWAYS set the saw for the
Thick Chuck.
• If the system is equipped with the Dressing Station option, adjust it to the
same level as the NCH / Button as described in this procedure.
• If the system is equipped with the Wash-pipe option, adjust it up/down by
the measured difference of Chuck's thickness.
Note: When physically replacing the chuck, ensure that the Theta table is
clean.