Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Blade Handling
P/N 97100-9002-000-14 Ver 06/05
7.4-13
7 Insert the new Blade into the Blade Holder (the Blade must be face
up).
8 Install the new Blade onto the Spindle.
9 Replace the Holding Nut and tighten it with the Torque Wrench (if
available) until there is a click.
10 Close the Cooling Block and tighten the Thumbscrew.
11 In the Define Blade screen, click OK.
12 (2” Spindle only) Tune the BBD by turning the Adjustment Nut of the
BBD (see
Figure 7-20) until the BBD Analog Sensor gauge in the Blade
Change tab of the Blade Information screen reaches the maximum
setting (see
Figure 7-9).
13 Continue turning the Adjustment Nut until the reading in the gauge
drops to approximately 12.
14 Raise the above value to 18.
Figure 7-19: 2" Blade Holder
Note: For 2" spindles the Torque wrench is set to 2.2 Nm
Note: Do not touch the Travel Securing Nut. It is preset in order to prevent
BBD crashing into the Blade.