Installation guide

Blade Handling
Advanced Dicing Technologies Ltd.
7.4-12
3 Attach the Spanner Tool onto the Torque Wrench and remove the
Holding Nut in the center of the Spindle by turning the Spanner Tool
clockwise.
4 Pull up the silver Release Ring on the Blade Holder and place the
Blade Holder over the Blade.
5 Remove the Blade by pulling it off the Spindle.
6 Release the old Blade from the Blade Holder by pulling up on the silver
Release Ring.
Figure 7-18: 4" Spindle with Cooling Block
Note: [2" Spindle only] If the Holding Nut cannot be removed with the Torque
Wrench, use the Hex Wrench (Allen Key).
Note: Steps 4, 6 and 7 refer to 2" spindles only.