Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual

Height Procedures

P/N 97100-9002-000-14 Ver 06/05

7.3-7

Sample Blade Calibration is performed at the factory and should be carried

out after Spindle adjustment or replacement.

To Perform Sample Blade Calibration

1 Accurately Measure the blade diameter (e.g. using microscope.)

2Go to SetUp > Saw > Cutting Block > Sample Diameter, enter the

blade diameter value in the relevant field and click Save.

3 Click on the Sample Blade Calibration button. The system performs

contact height on the chuck.

4 Wait until the wizard displays a message that calibration height is

completed.

7.3.5 Auto Height Compensation

The Auto Height Compensation feature is used to calculate the rate of

blade exposure and use this information to automatically adjust the blade

height in order to compensate for the exposure.

When this feature is activated, the calculated blade exposure as a function

of cut length is displayed in the exposure graph next to the actual

exposure. In addition, whenever the ADT Model 7100 Semi-Automatic

Dicing System uses the exposure calculation to automatically compensate

for the exposure, a blue caption is displayed on screen (see

Figure 7-5).

Note: Since this procedure is very delicate, it has its own access rights setting.

1 Compensation

Indication

2 Exposure

graphs:

green - actual

blue - calculated

Figure 7-5: Auto Height Compensation