Installation guide

Height Procedures
Advanced Dicing Technologies Ltd.
7.3-4
To Perform Button Height:
1 In the Setup & Diagnostics Workbook, select Saw > Dicer > Height to
display the Height tools, as shown in
Figure 7-2.
2 Click NCH/Button. The System lowers the Blade to the Height Device
and calculates the exact distance traveled. When completed, the
message "Contact Height completed" appears in the Wizard.
7.3.1.1 Change Button Procedure
When using a Mechanical Button as the Height device, the System
automatically tracks the number of Height procedures that can be
performed before the Button must be replaced. This number is displayed
after each Height procedure in the Activity Log at the lower left pane of the
screen. When the limit is reached, the System displays a message
instructing the User to perform the Change Button procedure to replace
the worn Mechanical Button with a new one.
To Replace the Mechanical Button:
1 Clean the area around the Mechanical Button so that it is free of dust
and water.
2 Click in the toolbar to display the Setup & Diagnostics workbook.
3 From the Setup & Diagnostics tree, select Saw > Dicer > Height.
4 In the lower right pane, click Change Button. The software switches
to the Video Workspace and displays the Wizard with instructions that
guide the User step by step through the procedure.
5 On the Mechanical Button housing, loosen the screw securing the
upper C-clamp and remove the C-clamp.
6 Remove the Mechanical Button by inserting a small screwdriver into
any of the four slots and prying upwards to release the Button.
7 Insert the new Mechanical Button into its housing, leaving it slightly
higher than it needs to be.
8 Replace and partially tighten the upper C-clamp.
9 Place a Straitness Block across the Chuck and Mechanical Button and
use the Block to press firmly on the Mechanical Button to ensure that
it is flat and parallel to the to the top surface of the Cutting Chuck.
Note: Remove the Workpiece from the Cutting Chuck before performing the
button replacement.
Note: The instructions given in the wizard do not replace the instructions given
in steps 5 through 16 of the present section.