Installation guide

Height Procedures
Advanced Dicing Technologies Ltd.
7.3-2
Process Height can be performed manually at any point during the cutting
process.
To Manually Perform Process Height:
Pause the dicing process, exit to Inspection. Then,
• Right-click on the spindle icon and select Height from the drop-down
menu.
or
• From the Manual menu, select Services > Process Height.
The System moves to the NCH station and lowers the Blade towards the
Height Device. The System calculates the exact distance traveled. When
completed, the message "Button/Non-Contact Height completed"
appears in the Wizard.
Height can also be performed when dicing is not in progress using the
Height tools in the Setup & Diagnostics Workbook in the Workbook
Workspace, as follows:
• NCH/Button Height section 7.3.1
• Chuck Height, section 7.3.2
• Chuck to Non-Chuck (Height Device) Delta Measurement, section
7.3.3
• Sample Blade Calibration section 7.3.4
Figure 7-2: Button Height Procedure Tools in GUI