Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Special Cut Procedures
P/N 97100-9002-000-14 Ver 06/05
6.5-11
6.5.6 Cut Depth Compensation
When Cut Depth Compensation category is activated, the System
automatically lowers or raises the Z-Axis to ensure a uniform cut width of
mid-way between the limits specified by the Max Cut Depth, Max and
Min Cut Width parameters. The System measures the width of the Bevel
cut during a Kerf Check. Cut Depth Compensation can only be performed
when the Kerf Check algorithm is selected in the Recipe’s properties and
the System is performing Kerf Checks.
When the cut is deeper than the limit (the street is too wide), an error
message appears and the cut depth is corrected for the next cut. After
performing a Teach Kerf Check during the process, followed by a manual or
automatic Kerf Check, the above correction is made based on the results
from the most recent Kerf Check.
The Cut Depth Compensation parameters define values used as
compensation when cutting with Bevel Blades. For more information, see
Table A-8.
6.5.7 Negative Index
This feature enables cutting in both directions: front to back and back to
front. Furthermore, it allows deciding the direction that the cut map is
built. To enable this feature, define the required parameters under the Cut
category. Refer to
Table A-10 , located under Appendix 3: “Recipe
Parameters”.