Installation guide

Special Cut Procedures
Advanced Dicing Technologies Ltd.
6.5-6
by the wizard. At the end of teaching process the following message
appears:
4 Click Yes.
Figure 6-40 illustrates the alignment lines for the two alignment
angles in a Multi-Panel application.
5 Teach the 90/5 (90 degrees) angle on panel #1 (the reference
workpiece), following the instructions given by the wizard. At the end
of the teaching process, the following message appears:
Note: It is important to take into consideration, that the workpieces in the Multi-
Panel applications must be rectangular unlike most wafers.
Figure 6-40: The Align Lines
4
2
13
1
3
24
0/1 (0 Degrees Alignment Line) 90/5 (90 Degrees Alignment Line)