Installation guide

Workpiece Alignment
Advanced Dicing Technologies Ltd.
6.1-28
6.1.9 Updating the Workpiece Alignment
Once the workpiece alignment has been taught, and there is a complete cut
map, the operator can use the Align Update tool in order to update the
existing cut map as required without having to reteach the whole sequence.
The Align Update tool allows the operator to choose which angle to modify
and which angle to skip (leave as it is), should there be any changes to be
done to the existing cut map. Likewise, the operator can modify specific
parameters for each alignment angle.
Clicking the Teach Align button pops up a dialog box:,
The operator can select one of the following:
• Full Teach: Update the whole cut map angle by angle
• Cut Positions: Update cut position only by moving the camera above
the cut position and updating it. The operator is instructed to click
Finish in the wizard once the cut position is updated.
• New: Teach a completely new alignment, i.e. create a new cut map
• Cancel: Cancel the procedure
Clicking Full Teach pops up an additional dialog box: