Installation guide

ADT Model 7100 Semi-Automatic Dicing System Operations Manual
Specifying Recipe Parameters
P/N 97100-9002-000-14 Ver 06/05
5.4-9
2In the Parameter area below the Parameter Tree, select a parameter
category from the Category drop-down list, as shown below:
3 Select a parameter from the Parameter drop-down list, as shown
below:
4 Click Add. The parameter is added to the Parameter Table with the
default value for the parameter assigned. (For more information about
default parameter values, see Appendix 1. To modify these values, see
section 5.4.3.2.2.)
5 Repeat steps 2-4 until all the parameters required for the tab have
been added.
6 Click . The new settings are saved to the Recipe.
7 Click the first Angle tab and repeat steps 2 through 6 to define the
parameters that are specific to that angle.
8 Repeat steps 2 through 6 for all additional Angle tabs.
5.4.3.2.2 Modifying Parameters
Users with read-write access can modify the values of parameters in the
Recipe at any time by performing the procedure described below.
Figure 5-20: Parameter Category List
Figure 5-21: Parameter List