Installation guide

Model 7100 Workflows
Advanced Dicing Technologies Ltd.
3.6-2
For additional information about Defining Jobs, see section 3.4. For
additional information about Recipes, see Chapter 5 and Appendix 3.
Run: Once the job has been defined, the System can be activated in Auto
mode by clicking the Run button
on the toolbar. From that point on,
System operation is entirely automatic. The User only needs to intervene
when changing a Workpiece or replacing the Blade.
Auto mode is halted if an error occurs while a Workpiece is being processed
or if the System detects any of the following:
• Alignment has not been taught
• Blade does not fit the assigned recipe
• Kerf Check has not been taught
Place Workpiece on Cutting Chuck: Each Workpiece must be properly
placed on the Cutting Chuck in order for the System to function properly.
For additional information about placing Workpieces on the Cutting
Chuck, see
3.6.4.2.
The User can perform the missing procedure, then continue running the
System in Auto mode.
For additional information about performing Alignment and teaching the
Index, see
Chapter 6.