User`s guide

AXIS 700 User’s Guide Basic Installation 9
10. Press Menu to display the subnet mask setting:
11. Press Enter to edit the subnet mask:
12. To change the value, repeat steps 4 - 6 above.
13. Press Menu to display the node address. This address is not editable. The node address
should equal the AXIS 700 serial number found on the underside label of the unit.
14. Press Menu once more to display the final instructions:
15. Press Enter to exit the Internet settings. The AXIS 700 then completes the startup
sequence.
16. Note the name or Internet address of the AXIS 700 on the instruction label and attach it to the
top cover.
When the Status indicator stops flashing and remains off, the AXIS 700 is ready for use.
Note:
Verifying the Network Settings -
To verify the network settings, you can access the
Advanced menu from the AXIS 700 control panel.
1. Press Menu a few times, until you reach the Advanced menu.
2. Use to find the Network Settings option.
3. Press Enter to enter the submenus.
4. Use to scroll through the parameter settings.
If you make a mistake when editing the parameters, press Cancel to cancel the previous
operation.