User`s guide

Using the AXIS 700 AXIS 700 User’s Guide
14
3. If you want to send the image to more than one destination, press Enter to select each
destination:
4. Repeat steps 2 and 3, until all desired destinations are selected.
Note:
5. Optionally, press Menu to change the default scanning parameters. You can select
temporary settings for scanning profile, paper size and double-sided. Use to select
the desired value.
Note:
6. Insert a single page on the flatbed or a stack of paper into the sheet feeder of the attached
scanner.
One single page or a stack of paper in the sheet feeder:
a. Press Send to scan and send the image to the selected destination in one step.
Several separate pages:
a. Press Scan to scan each page.
b. Insert the next page and press Scan again. Repeat the procedure until all your pages
are scanned.
c. Press Send to transmit the image to the selected destination.
7. During the scanning this message is displayed:
When you have pressed Send and the transfer of the scanned image is completed, the AXIS
700 is released for other users.
Note:
✓
Be careful not to transmit images to an unwanted destination. The scanned image will
always be sent to the destination currently shown, whether explicitly selected or not.
Press Cancel to reset all temporary settings to the default values.
The AXIS 700 keeps all temporary settings in memory for one minute after the last scanning
job, and then returns to its default settings.