User`s guide

AXIS 70/70U User’s Guide Using the AXIS 70/70U

Note:

6. Optionally, press Menu to change the default scanning parameters. You can

select temporary settings for profile, paper size and double-sided. Use

to select the desired value.

Note:

7. Insert a single page on the flatbed or a stack of paper into the sheet feeder of

the attached scanning device.

For one single page or a stack of paper in the sheet feeder:

a. Press Send to scan and send the image to the selected destination.

For several separate pages or stacks of paper:

a. Press Add Page to scan each page/stack.

b. Insert the next page/stack and press Add Page again. Repeat the

procedure until all your pages are scanned.

c. Press Send to transmit the image to the selected destination.

8. During the scanning this message is displayed:

9. When you have pressed Send and the transfer of the scanned image is com-

pleted, the AXIS 70/70U is released for other users.

Note:

Adding E-mail Destinations

The e-mail list resident within the AXIS 70/70U is initially created by your

administrator. If you want to send a document to an e-mail destination that is

not featured in the list, you can add a temporary e-mail destination using a

standard PC keyboard

The image will always be sent to the destination currently shown, whether explicitly selected or

not. So, be careful not to transmit images to an unwanted destination!.

Press the Cancel button to reset all temporary settings to the default values. All selected

destinations will be cleared.

The AXIS 70/70U keeps all temporary settings in memory for one minute after the last scanning

job or until user has logged out, and then returns to its default settings.