User`s guide

Using the AXIS 70/70U AXIS 70/70U User’s Guide
20
Using the AXIS 70/70U
The services provided to normal users are determined by the administrator
when configuring the product. This section describes all services that can be
made available to a user, namely:
• Sending to destinations
• Adding temporary e-mail destinations
• Viewing the images
• Specifying a sender
Note:
Sending to Destinations
Follow the instructions below to send information to one or several e-mail
destinations - directly from the AXIS 70/70U control panel:
1. The AXIS 70/70U is ready for use when the following message is displayed:
2. Where
xxxxxx is the destination name.
Note:
3. Use the scrolling keys to find your required destination in the list.
Press and hold the key to autorepeat scrolling. If you want to add a temporary
e-mail destination, refer to Adding E-mail Destinations, on page 21.
4. If you want to send the image to more than one destination, press Select
to choose each destination:
5. Repeat steps 2 and 3, until all desired destinations are selected.
Administration instructions for setting user privileges are provided in Specifying System Settings,
on page 18.
If the following message is displayed your administrator has enabled authentication and you
must enter your user name and password. For further information, please refer to the AXIS
70/70U/7000 User’s Manual at the Axis Web site http://www.axis.com or on the AXIS Network
Product CD.