User`s guide

AXIS 70/70U User’s Guide Basic Installation

Assigning an IP Address to the AXIS 70/70U

Follow the instructions below to set the IP address from the Control Panel.

Important!

1. Power up the AXIS 70/70U and press Menu when this message appears:

2. After a few seconds this display will be shown:

3. Press Select to edit the IP address:

4. Press Menu to move through and highlight each digit, one at a time.

5. Use to increase or decrease each highlighted digit, as required.

6. Press Select to confirm the changes.

7. Press Menu to display the default router address setting:

• This section can be ignored if you are using DHCP, RARP or BOOTP, as the IP address is set auto-

matically (DHCP is the preferred method for Windows NT networks, as it automatically sets

some of the parameters as well).

• A valid and unused IP address must be acquired from your Network Administrator.

• Connecting a PC-AT keyboard directly to the mini-DIN connector on your AXIS 70/70U pro-

vides a convenient method for managing the unit, and setting the IP address during system

start up. The administrator can choose to disallow this function from the Administration

pages. Please make sure that the AXIS 70/70U power supply is disconnected before connecting

the keyboard.

• The IP address for your product can also be set using the AXIS IP Installer (included on the

AXIS Network Product CD), or the ARP, RARP BOOTP or DHCP methods.

Please refer to the AXIS 70/70U/7000 User’s Manual for further details.